A Halden company - serving Las Vegas, NV

Rheem Furnace Repair Nationwide

Furnace & heatingFurnace & heating
AC repairAC repair
Heat pumpsHeat pumps
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

Your new heating and cooling system for as low as$119/month*On approved credit; ask for current terms

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Rheem Furnace Repair in Las Vegas: What to Know First

Rheem furnace repair in Las Vegas typically runs between $150 and $700, and most jobs are completed the same day our tech arrives. We’re an independent Rheem service provider, not a Rheem-authorized dealer, which means we make parts and pricing calls based on what’s actually right for your furnace and your budget, not what a manufacturer program tells us to do.

Call (725) 220-3488

If you own a Rheem furnace and it’s blowing cold air, short-cycling, or making a sound it didn’t make last week, this page tells you what’s likely going on, what it costs to fix, and how fast we can get to you. Call (725) 220-3488 and a real person picks up, 24/7. No voicemail maze.

How Rheem Products Fail – and How We Fix Them

Rheem builds solid furnaces, full stop. But every brand has a personality, and after two decades in Las Vegas attics and closets, we know Rheem’s quirks better than most. Here’s what we see on a typical week:

  • Pressure switch fluttering on Classic Series 90+ units – the Classic 90 line, especially units from the 2009 – 2016 era, runs a pressure switch that’s sensitive to intake restrictions. Las Vegas dust is brutal. What starts as a minor restriction in the intake pipe causes the switch to chatter, which gets misread as a control board problem. We clean or swap the switch and inspect the intake run first, because replacing a board without clearing the pipe just brings the same problem back in three weeks.
  • Ignitor failure on Rheem R92T and R96V models – these mid and high efficiency lines use a hot surface ignitor that gets brittle with age and cycles. If your furnace tries to light, you hear the gas click, but no flame catches, that ignitor is the usual suspect. We carry the Rheem-spec ignitors on the truck so we’re not driving across town for a part.
  • Draft inducer motor wear on older RGRM and RGLH series – these are workhorses, but the inducer motor bearings get noisy and eventually seize, which shuts the whole furnace down with a pressure-related fault code. Las Vegas homes with furnaces in unconditioned garages see this more often because of the summer heat cycling, and no, the attic isn’t much kinder. We replace with OEM when the unit is under warranty or the customer wants factory-spec, and we’re upfront about quality aftermarket options when it makes financial sense.
  • Flame sensor carbon buildup across all Rheem lines – this is the most common no-heat call we run on Rheem furnaces, bar none. The flame sensor gets a carbon film, stops sensing the flame, and the furnace lights then shuts off in under five seconds. It’s usually a 20-minute fix involving cleaning the sensor with the right abrasive. We explain this because about half our customers assume they need a new furnace when all they needed was a clean sensor and a $150 service call.
  • Control board failures on Rheem Prestige series condensing furnaces – the R96V and R97V modulating furnaces are efficient machines, but the control boards do a lot of work, and Las Vegas power fluctuations during monsoon season don’t do them any favors. When a Prestige board goes, the symptom is often erratic blower behavior or the furnace ignoring thermostat calls entirely. We test before we condemn a board, because a wiring issue or a failed limit switch can mimic the same symptom and cost half as much to fix.
Explore

Styles & brands we work with

AC repair
AC repair
Furnace & heating
Furnace & heating
Heat pumps
Heat pumps
Ductless mini splits
Ductless mini splits
Carrier
Carrier
Trane
Trane
Goodman
Goodman

Our Rheem Furnace Repair Process

Here’s what actually happens when you call us for a Rheem repair in Las Vegas:

  1. 1
    You call or book online. A live person answers, asks what the furnace is doing (or not doing), and gets a tech dispatched with a live arrival time you can track on your phone.
  2. 2
    We show up and listen. Before we open a panel, we ask what you noticed: when it started, what the air smells like, whether the thermostat is doing anything weird. Half the diagnosis is in your description.
  3. 3
    We diagnose, then write the price down. We test the suspect components, identify the fault, and hand you a written price before any work starts. The price doesn’t change at the door, because it’s on paper.
  4. 4
    We make the repair with the right parts. For warranty-covered Rheem parts, we use OEM. Otherwise, we recommend the best value between OEM and proven aftermarket parts, and we tell you the price difference and why we’re recommending what we’re recommending.
  5. 5
    We test the furnace through multiple cycles. We don’t just turn it on and call it good. We run the furnace through several full heating cycles, check the temperature rise across the heat exchanger, and verify that no fault codes return. Andre Fuller’s rule: the air coming out of the vents has to match what we promised before we leave.
  6. 6
    You get a written guarantee and a 365-Day Done Right Promise. Every repair carries a written guarantee. If the same issue returns within the coverage window, that second visit is free, automatically. No arguing, no fine print.

What Rheem Furnace Repair Costs in Las Vegas

Rheem furnace repair in Las Vegas runs $150 – $700 for the overwhelming majority of jobs. The cost lands wherever the part and the labor land, and we put it in writing before we touch a screwdriver.

Here’s how typical Rheem repairs break down:

  • Flame sensor cleaning or replacement: $150 – $275. The part is under $40; the rest is the diagnostic time and the multiple test cycles.
  • Ignitor replacement: $225 – $375 depending on the Rheem model. R92T and R96V ignitors are slightly different than the Classic series, and OEM pricing reflects that.
  • Pressure switch replacement: $200 – $360. We always include a check of the intake and exhaust piping with this one, because a dirty pipe can kill a new switch in a Las Vegas heating season.
  • Draft inducer motor replacement: $450 – $700. This is the upper end, and it’s more labor than parts cost. Some older RGRM inducers are getting harder to source, which makes the OEM price meaningful.
  • Heat exchanger repair or replacement: If the heat exchanger is cracked, we’ll show you the photos. On most Rheem units, a heat exchanger replacement is a big-ticket item that often tips the repair-vs-replace conversation toward a new furnace, and we’ll be straight with you about that math.

Every estimate is free, every price is locked before work starts, and we never hit you with a “while we’re here” upsell. Call (725) 220-3488 and we’ll give you a real number, not a guess.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Why Las Vegas Homeowners Call Halden Heating and Air Las Vegas for Rheem Work

We started Halden Heating and Air in 2004 because the HVAC industry had a bad habit of keeping prices in a tech’s head and springing them on people at the door. Two decades later, our process has not budged: written price before work starts, written guarantee on every repair, and a free second visit if the fix doesn’t hold. We call it the 365-Day Done Right Promise, and it’s included with every job. Not sold as an add-on. Included.

Our techs are background-checked, uniformed, and sent with a live arrival time you can track from your phone. When your Rheem furnace quits on the coldest night of the year, you’ll know exactly who’s coming and when. And while Rheem is a big part of our repair volume in Las Vegas, our techs also run service on Carrier, Trane, and Lennox daily, which means we’re not a one-brand shop trying to fit your Rheem into someone else’s playbook.

Andre Fuller, our owner, has logged more Rheem service calls in Summerlin, Henderson, and North Las Vegas than he can count. He still remembers his first Las Vegas July after moving from LA, realizing a desert summer is a different animal entirely. That’s why the phrase around here is simple: “If I wouldn’t put it in writing, I wouldn’t say it.”

FAQs

Call Halden Heating and Air Las Vegas for Rheem Furnace Repair

If your Rheem furnace is misbehaving, don’t guess at the problem and don’t wait for it to sort itself out. Call (725) 220-3488 for a free estimate and a real person on the other end, any hour of any day. We’ll give you a written price, a live arrival time, and a guarantee in writing before we pick up a tool. That’s the Halden way, and it’s been that way since 2004.

Written by Andre Fuller, Owner, Halden Heating and Air Las Vegas, serving Las Vegas and nearby areas.

Need HVAC help in Las Vegas? Licensed & insured · within the hour response · free estimates
Call (725) 220-3488
Local Service Coverage

Request a Free Estimate in Las Vegas

Tell us what you need - Halden Heating and Air Las Vegas responds fast. No obligation.

By reaching out through this form, you confirm you have read our Privacy Policy and agree to be contacted via phone, email, or SMS about your service request, including from the local pros who may handle it.

Prefer to text? Text Now
Call Now - 24/7 Dispatch